The five-axis controller is the core of the five-axis processing machine, which is used to control the trajectory of the five-axis simultaneous motion and the compensation of the motion.

The turning process is to make the material reach the desired shape by removing the material, and its machining accuracy is high and there is no mold restriction. But the production cost is high and the processing speed is slow.

The Southeast Asian Manufacturing Alliance, initiated by Singapore, is mainly characterized by orderly and divided industrial zone planning. Singapore is a market entry hub and a high-tech development center.

In pipeline construction, the elbow is a commonly used pipe fitting. Because the construction environment is different, the use environment that the pipeline component will face is different, so the types of elbows are also various. There are strict requirements in the processing of elbows. If the processing environment is affected, there will be certain defects after the final elbows are formed, which will affect the quality of the project.

Different types of milling cutters can be used to cut large amounts of material and leave poor surface smoothness (roughing) or to remove smaller amounts of material but leave good surface smoothness (finishing).

Drilling machines perform different operations as the manufacturing process involves holes to be completed. Different drills must be required for each type of work.

Milling machines have better chip evacuation because of the nature of their configuration because gravity keeps the chips from falling. This helps improve the surface finish and prolongs the life of the tool.

Shaft parts are one typical part of machining. The shaft part is a rotating part whose length is greater than the diameter, and its surface is several outer cylindrical surfaces, conical surfaces, holes, and threads of the same axis.

Collet is a cylindrical fixture used to install a drill bit or a milling cutter on a milling machine. It is a fixing device used to fix and reinforce parts that need to be modified.

A grinder is a widely used abrasive processing process in which a spinning wheel is covered with coarse grains. Cutting pieces of metallic or non-metallic substances from a workpiece to make the surface flat or smooth.

In the chip formation process, materials are cut through mechanical means by using tools like milling cutters, saws, and lathes. It is an integral part of the engineering of developing machines and cutting tools.

A worm gear is a gear consisting of a shaft with a helical thread that meshes with and drives the gear.

A drilling machine is a machine tool primarily used for making a round hole or driving fasteners. A drilling machine is used for the drilling process, and it is also the processing technology often required in manufacturing production.